13" MacBook Right Speaker Replacement
Use a coin and turn the battery lock 90 degrees.
Stacks Image 414
Lift and remove the battery.
Stacks Image 416
Fully loosen, three Phillips screws along the back of the battery compartment. These three screws are captive and do not come out. They remain in place on the RAM cover.
Stacks Image 418
Pull the RAM cover back and then lift it out of the computer.
Stacks Image 424
Look on the bottom of the case and remove three Phillips screws. The two screws in the rear are 14.5 mm and the center screw is 11 mm.

The two rear screws, 14.5 mm, may or may not come out of the case easily. If you can use a magnet, tweezers, or leave them in. If you leave them in just be 100% certain they are fully loosened.
Stacks Image 478
Three Phillips screws on the rear wall need to be removed. The outside screws are 4mm and the center screw is 3 mm.
Stacks Image 383
Looking to the right, remove two Phillips screws. The screws are 6.25 mm.
Stacks Image 424
Four Phillips screws need to be removed. You need to remove the second, fourth, seventh, and ninth screws counting left to right.
Stacks Image 478
Look at the back of the MacBook. Remove four Phillips screws. The inside screws are 11 mm and the outside screws are 7.25 mm.
Stacks Image 383
Remove the two Phillips screws on the side of the optical drive. The screws are 5.2 mm.
Stacks Image 424
Gently pry the keyboard upward starting at the rear, near the screen, working your way to the front toward the track pad. The keyboard may stick over the top of the optical drive. If this happens, pry the other three sides free and then pull directly up on the keyboard over the optical drive.

Please be careful as the ribbon cable from the keyboard to the logic board is very short.
Stacks Image 478
Hold the keyboard up and pull the black tab on the ribbon connector up off the logic board.
Stacks Image 383
Pull the white tab on the hard drive tot he left. Then carefully set the hard drive to the side out of harms way.
Stacks Image 351
Remove two Phillips screws from the outer case of the optical drive bay. They are 3.25 mm screws.
Stacks Image 402
The optical drive ribbon cable needs to be disconnected by lifting up on the connector.
Stacks Image 409
Locate the display data cable attached to the logic board by pulling up on the tab. It sits to the right of the optical drive connector.
Stacks Image 432
Locate the hard drive cable connector and disconnect it by pulling up on the tab. This connector sits to the right of the display data cable connector.
Stacks Image 439
Pull back the tape off the optical drive back toward the fan.
Stacks Image 446
You will need to pull up the display data cable a bit to locate a small 2 mm Phillips screw. The screw helps secure the optical drive in position. A lot of caution should be taken because there are several cables, including the Bluetooth cable, that run through this raceway over the Phillips screw.
Stacks Image 469
The hard drive cable needs to be temporarily rerouted. The cable runs the length of the optical drive and is retained by several clips.
Stacks Image 480
Lift the side of the optical drive closest to the front of the computer up and slide it out of the computer.
Stacks Image 500
Remove four Phillips screws. One is 7.5 mm in length and the other three are are 3 mm length. Depending on your MacBook, the screws may be in an alternate location. The locations to the right are for the Penryn Core2 Duo.
Stacks Image 512
Remove the right speaker out of the case.
Stacks Image 519
Remove the speaker and assembly underneath the display data and microphone cables.
Disconnect the right speaker cable connector from the logic board.
Stacks Image 559